Opt 150 3478mhz, stable

[Gadflyii]

Got my new OPT 150 CABNE (IHS still on the chip) up and running with the SLi Expert board.. I am loving it so far :), no prime yet. I think with a touch more vcore, I can get it to run at 3500. I can run a 1M at 3500, but anything more than that it errors out.

The 3dmark is at 521mhz core 1360 memory (I think, can't remember what it is set at) NV5 Rev.3 with Ramsinks, and i replaced the fan with higher CFM unit.


Anyway.. back up and running.. I'll mess with it some more tommorow.

http://www.gadtek.com/150-3478.jpg

[andL64]

very nice oc !

these opterons are really good clockers. what cooling did u use?

but this 05 score is low for 512/1360 and 3478mhz.

seEn

[ShadowClock59]

I agree, at 2.9 and 500/1400 I get about 9200+. Is everything set to high performance?

[Gadflyii]

I thought so as well.

With 500/1400 I pulled down a 9264 this morning, and that was with everything set at high performance, AND a 50mhz delta bios. I Should be pulling much better scores.. Guess I will have to seek some advice on how to set up for 3dmark.

Cooling is stock vaporchill LS.

http://service.futuremark.com/compare?3dm05=1452720

[ShadowClock59]

That looks about right for a single core with thoughs drivers. Now if you were running thoughs clocks on a dual core Opty im sure it would be a whole different story, that would actually be interesting to see... :slobber:

But congradulations on the overclock, thats a pretty massive accomplishment. :clap:

I hear the new betas are once again improved, might wanna try them and see if anything changes.

Good luck. :thup:

[geto]

very nice clocks

[Gadflyii]

Thanks guys, I was able to get my 3dmark score up to 9404 tonight, I am running it for the second pass now, I will post the link once published.

I will try the new beta's see what i can get out of them.