Dothan vcore pin mod

[yike99]

anyone know how to read this site or know which pins have to be wired together to get a little bit higher voltage? Looks like i am using 1.35 volts and would like to bump it up to 1.4 or 1.45. The bios does not have these options.

http://www.freewebs.com/newblackdak/dothan.html


thanks

[p0rl1n]

its kind of like the vid 4 mod, but i guess you'd call it the vid 2 mod.
check out this thread:
http://www.xtremesystems.org/forums/showthread.php?p=812512#post812512
If you don't want to give it that much volts you can take it slow and bridge VID2 to VSS to get 1.404V

so instead of jumping g4-f4 jump f3-e3.

[wwwww]

I prefer VID5 to a vss so that by default, it's still 1.34V, but you can adjust in bios (assuming you have an adjustable vcore), right up to 1.7V (by setting 0.7V to 1.196 you'll get 1.212V to 1.708V).

[yike99]

thanks guys. great site, but the computer would start up everytime at 133 fsb and even after upping it a little bit after saving the setting and restarting the fsb goes back down to 133. So i am not to sure what that is about. btw i have that aopen board so no adjustments for voltage in the bios