Side mounting kit ...?

[NothingToLose]

is there a side mounting kit for the Blue Quad 120mm Heater Core rad if so where can i get it?

[NothingToLose]

i guess there isn't =(

[MaxxxRacer]

what do you mean by side mounting kit?

[Brandon_Tyler]

I'm thinkin he means mounting the core to either the door side or tray side of his existing case maybe!?!??!?!?

-B!

[NothingToLose]

I'm thinkin he means mounting the core to either the door side or tray side of his existing case maybe!?!??!?!?

-B!

^^^^^^

[Quazi]

If you wanted to spend the $$$ for two RadBoxes from SwiftTech, this would get the job done. Myself, I ask the guys at Voyuers to cut the allthread 3" longer than usual. I am then going to screw a nut down just far enough down each end of allthread to push each allthread through the case side to screw nuts on the back side of each. I'll do this on each corner. I spoke at length with the guy and explained the reason I needed to have the allthread that holds the shroud and the fans on that heatercore 3" longer. After he grasped what I wanted to do, he said that should hold the radiator just fine, and actually told me this was a good idea. My wc components should be here next Wednesday or Thursday. If you want, I'll post a pick and let you know how it works out. Doing it this way saved me $52 because I was going to get a couple Radbox kits and rotatate that radiator at a 45 degree angle to have a rabox at the top and bottom. Still may go this route if the way I described aboved doesn't work out. But I do believe it will.

[NothingToLose]

yea if you could post a pic that could be helpfull but otherwise i'll just lean it up against my window sill

[moonlightcheese]

i'm doing something similar with my box. cut open a hole in the case and i'm pulling air through the rad with two panaflos. i'm making an aluminum flange support and i'll be covering that with a fiberglass top that will look something like a ram-air intake. i'll post pics when fabrication is complete.