GX Clocking Fun

[Tulatin]

Well, seems that nobody out this way has clocked GX quite yet. So, the fun starts tomorrow, this is some good :banana::banana::banana::banana: :) . We'll see clocks in the morning.

[NinjaWreck]

You mean GX as in the OCZ ram?

[Tulatin]

As in Gamer's Extreme. Yup

[dnottis]

Not looking hard enough?

http://www.3dxtreme.net/index.php?id=oczpc3500gx-pc48001

[Tulatin]

By out this way, i mean in this forum. I've seen it covered at other places too.

[red_dragon]

Highest I got was 261 MHz 2-2-2-8 @ 3.6V. Not too shabby if you ask me.

[OV3RCLOCK3R]

Whats chips does this memory use? UTT/BH5/?

[SlackeR]

New BH for 2-2-2 at low volts.

[TheMeatFrog]

Highest I got was 261 MHz 2-2-2-8 @ 3.6V. Not too shabby if you ask me.
Not bad, but I think if your going to put the volts in them VX is the way to go. The VX 3200 are cheaper than the GX and have a higher chance of scaling better with higher voltage.

The GX will however do DDR433 2-2-2-5 easy at 2.8v where VX needs 3+ volts to run the lower latencys at the same speed. So it all really depends on what your needs are and what your looking for out of your memory. :)

I like to see how these compare to the regular EL Gold that uses the same new BH-5. :)

[situman]

VX has a higher tendency to die cause its CH die. made on a smaller die process than BH, and we all know what happens when u put too much volts through a small die chip. Anyone remember GNDS (gradual northwood death syndrome) or SNDS (sudden...)?