thecowboy
07-01-2005, 07:37 PM
So I just got a DFI LanParty UT nF3 Ultra-D and a 3500+ Venice. I hooked it all up and it was working fine for a day or two, then when I try and boot everything spins up, hard drives, fans, optical drives. But the screen never comes on, no beep like I usually got. Also, the Power LED now blinks slowly...
Now I tried both a 375w PSU and a Antec TruePower 550(older first version) but I get the same result.
I tried clearing the CMOS for 30sec and 10min, but still no go
EDIT: Not sure if this is relevant, but I installed a Raptor drive today, it booted up fine the first time and I formatted it. But then I decided I would reformat all my drives and when I rebooted this time is when my problems occured
Now I tried both a 375w PSU and a Antec TruePower 550(older first version) but I get the same result.
I tried clearing the CMOS for 30sec and 10min, but still no go
EDIT: Not sure if this is relevant, but I installed a Raptor drive today, it booted up fine the first time and I formatted it. But then I decided I would reformat all my drives and when I rebooted this time is when my problems occured