Filling up Caps on P4C800 1.03

[kryz]

Hi,
I just got a used p4c800 for my ct-479.
I'm going to do the other mods like vdimm and Vcore but there als a lot of free cap places an also some more room for additional fets.
What shall I do with them?

thx

Chris

[Malves]

Leave them alone?

[kryz]

hmmmm... NO :D

btw, I hat a look at (your?) site to check out the other Vmods:

http://www.malvescorner.net/p4c800.html

The vdimm and the Vagp shouldn make any Problems, but I can't follow the droop mod!

Chris

[Malves]

Why? There are 2 ways to do it. Pick one and you are all set.

[kryz]

yeah, i decided to do it the first way.
But the soldering point for the right wire(on the pic) seems a bit small. Is this just ground or do I have to solder it there?

back to the caps:
What about filling up CE146 and CE149 with 6.3v 1500uF ones? (the same the other in this row are)
I just want to get the max of the board :D

[Malves]

You have to use the points shown, otherwise it won't work.

[kryz]

okeh.. so just solder the second one on the point i don't have to scratch up anything, do I ?