gclg2000
05-21-2005, 10:22 AM
Chilly sent me this block that was messed up by someone else he sent it to and then they sent it back.
Before and after pics are below, i got my buddy to help me turn it down on a laythe machine to reexpose the spiral threads and then just faced the ends off...i will use this and put it in a DICE/LN2 container of my own. :toast:
**Notice the END of the cap tube in the very top most layer of the block, whoever assembled this block only ran the cap tub to the first layer of the block and it was right next to the suction port....not very smart, the gas was basically evaporating into the suction port...and not going around the spiral block itself.
BEFORE
http://www.namike.com/albums/Cascade-Build/DSCN0650.jpg
AFTER
http://www.namike.com/albums/Cascade-Build/DSCF0009_001.jpg
http://www.namike.com/albums/Cascade-Build/DSCF0005_001.jpg
Before and after pics are below, i got my buddy to help me turn it down on a laythe machine to reexpose the spiral threads and then just faced the ends off...i will use this and put it in a DICE/LN2 container of my own. :toast:
**Notice the END of the cap tube in the very top most layer of the block, whoever assembled this block only ran the cap tub to the first layer of the block and it was right next to the suction port....not very smart, the gas was basically evaporating into the suction port...and not going around the spiral block itself.
BEFORE
http://www.namike.com/albums/Cascade-Build/DSCN0650.jpg
AFTER
http://www.namike.com/albums/Cascade-Build/DSCF0009_001.jpg
http://www.namike.com/albums/Cascade-Build/DSCF0005_001.jpg