once again i cant overclock for §§§§

[[H]AMDGamer]

first my KX7-333R now my A7N8X if i set it to 211FSB it wont even boot but 200FSB does ok

now i got a stick of corsair PC3500 so it shoudint be a problem

so far my career in overclocking is not off to a good start:(

[Kunaak]

thats alittle too vague.

what CPU are you using?
what voltages are you trying?
divider?
videocard?

have you downloaded the 4-1 drivers?

theres alot to consider.
need more info if you want advice.
theres plenty of people that can help here.

[felix88]

4 in 1 drivers are not needed for an nforce2 board.

more system specs would be helpful. if i remember correctly, your power supply is most likely not cutting it.

[SpudHo]

If I where you I'd check out the A7N8X thread big read but worth it.

http://www.xtremesystems.org/forums/showthread.php?s=&threadid=4790&perpage=25&pagenumber=1

[[H]AMDGamer]

ok my specs are

A7N8X
Xp-2000+ Tbred( factory unlocked)
Gainward GF3 Ti200
Corsair PC3500 256MB RAM


both the GF3 and Xp-2000+ are watercooled

now any FSb above 200MHZ is not stable i was having this same exact problem on my KX7-333R now with the ram i got it should b able to do an easy 220MHZ FSB i dont understand why i cant overclock on these boards maby it is my cheap 300W PSU?

[felix88]

try a better psu and then check back with us.

[Kunaak]

some AGP cards have a tendency to mess up at certain OC's.
the 9700 for instance in my case goes nuts around 196.

that may be part of the problem.

[Justintoxicated]

are you sure that 2000 will run 211 FSB? Is that the same CPU you tried to OC before but could not hit 1800 MHZ?