IT7-MAX2 users

[will_perdikakis]

I heard that this board had 3.0v selectable DRAM voltage, but in my BIOS it is only selectable to 2.8v, what am I missing here?

Any other hints/tips you guys could lend me? Much appreciated.

[wdd1040]

Search for the modded BIOSes. They allow settings of up to 3.2, but most boards will only hit 2.99 MAX unless you really crank up the PSU Rails.

[Creative]

U have to use a modded bios to allow these features to be revealed in the bios.

Jupiler has a modded C6 bios. I must admit I forget which thread the link was in though...:(

[will_perdikakis]

Thanks guys.

Do these BIOSes enable higher vcore as well? My CPU needs more volts too, I could swear I did the wire trick on it. Oh well, Better if I soldered it anyway. :)

Stuck at 3300Mhz. :(

Any hints as to where to look for these BIOSes?

[Ace-a-Rue]

Here is the link for the mod bios:

http://www.xtremesystems.org/forums/showthread.php?s=&threadid=4949

[will_perdikakis]

Have any IT7 users noticed any improvements in performance with "Enhance" enabled?

[Creative]

Enhance changed the SDRAM Idle Clock timer to 0

It gives me about 50-100 more points in 3dmark but also causes alot of instability.

When turned off I can get about 2-3 more fsb than when I have it set on...:)