g skill la help

[pancake]

got my la today finally. they seem to be running fine with all the timings set to auto in my dfi ultra d @ 1T , they went through test 5 looped of memtest for 30 mins no errors. need some help on setting the timings manualy as im sure auto is not the best setting to have as there currently doing 300 2.5-4-4-8 1T. anyone used theese on a dfi nf4 ? what settings and volts were you using to get best performance at theese speeds or higher. currently getting around 7542 mb\s in sandra

thanks
matt

edit: trying to run sandra mem bench at 318fsb , and it pops up a window saying "module could not be updated this may be due to the computers current configuration" what gives? super pi 16m ran fine prime runs ok just sandra wont run mem bench itll do cpu bench

[HARDCORECLOCKER]

got my la today finally. they seem to be running fine with all the timings set to auto in my dfi ultra d @ 1T , they went through test 5 looped of memtest for 30 mins no errors. need some help on setting the timings manualy as im sure auto is not the best setting to have as there currently doing 300 2.5-4-4-8 1T. anyone used theese on a dfi nf4 ? what settings and volts were you using to get best performance at theese speeds or higher. currently getting around 7542 mb\s in sandra

thanks
matt

edit: trying to run sandra mem bench at 318fsb , and it pops up a window saying "module could not be updated this may be due to the computers current configuration" what gives? super pi 16m ran fine prime runs ok just sandra wont run mem bench itll do cpu bench

:D In Ya SIG only shown the BH-5, is Ya G.Skill also 2 x 256 ?

Try 2,5-4-3-7 and notice that G.Skill LA 256 modules are rated 1T but 512 modules are rated 2T.

Sure, 512 modules will also perform well at 1T but heard of that the 512 LE will do a bit better.

:toast:

[pancake]

yea forgot to say there 2x512. got them currently doing 305 2.5-4-4-8 1T had to lower my cpu overclock from 2700 to 2600 as it didnt like anything above 2650 should i keep my cpu that low and try to get the memory a bit higher , or lower the memory a bit so i can get back to 2700?