Flashed Leadtek 6800GT

[isp]

I just flashed my Leadtek 6800GT 256mb with wfflash and the Rev05 rom from MVKtech. Before the flash, the the rom was edited to increase the voltage from 1.3 (stock I assume?) to 1.4. After I successfully flashed the clocks have gone up about 30mhz or so on the core etc and quite a bit on the mem. Not bad. I didn't notice any increase in temps from from the Nvidia monitor, should there of been an increase? I assume the voltage went up, otherwise I don't have anything to attribute the higher clocks to. To put my mind at ease though, is there an easy way I can get a definite reading gpu voltage?

...and one last thing :)
Is 1.4 the most you would go with the leadtek stock cooling? I thought I've read of some fellas getting 1.5v. The only other option I saw in Nibitor was 1.6V, and I wasn't sure on that... :stick:

[Mavke]

Well some have done already the update on a GT from 1.3v to 1.4v and gotten good speed increase. From 1.4v to 1.5v is a bit less good succes and most don't want to use it unless some who have watercooling systems on their graphics card... The 1.5v - 1.6v is the same, but on some it reports closer to 1.6v then 1.5v. That is why the naming 1.6v rather then 1.5v. ;-)

[isp]

I see...

I'll hold off on upping it anymore then until I get some better cooling on it. Thanks MVK.

[dfx]

Dude,
PCIe or AGP?
Thanks

[isp]

The card is AGP. Sorry I sometimes forget about this new stuff. :p:

[dfx]

Mine is a PCIe
Dont whether can it be perform or not :confused: