My Chiller

[DocGolem]

Well, I finally got her hooked up after a dead motherboard or two. :banana:

I haven't pulled her all the way down so I can't give you guys any temperatures, but it's working out very well. MUCH quieter than my 92mm Tornado at full speed :). Don't mind the wires, they're a mess. With just the GPU hooked up on the loop, it got down to -18C full load, I'm guessing/hoping to get -10C fully loaded with the CPU/GPU. The res is quite large, about 2.5 gallons of a 60/40 mix of antifreeze and distilled water.

Here's some pictures:
http://www.xtremesystems.org/forums/attachment.php?attachmentid=26149&stc=1
http://www.xtremesystems.org/forums/attachment.php?attachmentid=26150&stc=1
http://www.xtremesystems.org/forums/attachment.php?attachmentid=26151&stc=1
http://www.xtremesystems.org/forums/attachment.php?attachmentid=26152&stc=1
http://www.xtremesystems.org/forums/attachment.php?attachmentid=26153&stc=1

I'll mess around with it this afternoon when I get done with school and try to get some results!

[caLume]

looks a bit messy :)

pls take some pics of the whole sys.

nice by the way :D

[DocGolem]

Here's a side shot and a shot on how it sits now. I cut a little bit into the cooler to allow for the lid to close while having the copper tubes going into the cooler. The res is pretty large and not very efficient, but it's working fine for me. If you need any more pictures, I can get some more.

http://www.xtremesystems.org/forums/attachment.php?attachmentid=26164&stc=1
http://www.xtremesystems.org/forums/attachment.php?attachmentid=26165&stc=1