Shuttle I.C.E. Mounting holes.

[Jaite]

I'm looking at a watercooling system for my SN95G5, and I noticed that the mounting holes weren't the standard 2 for socket 939s, but a 4 hole configuration. Now I'm kinda confused as to which waterblock I should pick. I was thinking about the TDX s939, but now I'm doubting it would fit (diagonally that is). The S775 looks as if the holes are too far from the socket. Could someone point me in the right direction for choosing a good 1/2" waterblock for my barebone system?

[killzone]

use a P4 style water block with it. I believe it uses the P4 skt 478 retension module, so any block that mounts using the p4 retension. Also if u arent using the retension module the holes (4) are the same as the P4 478 boards. So a block setup to use a pass through install will also work

I know its wierd P4 478 Style mounting on an AMD rig

[Jaite]

Ah, okey. Would a DD TDX S775 fit?

http://www.overclockers.se/catalog/images/new/tdx775.JPG

[killzone]

no that is for soket-t you need a socket 478 cooler and or block

[MaxxxRacer]

just get the tdx for socket 478 like killzone said. danger den (the maker of the TDX) has it on their site. make sure to get the brass topped one.

[Jaite]

Well, I would have but I live in Sweden. Shipment and taxes make the prices go way high, and I'm having a hard time finding a retailer for it here.

[MaxxxRacer]

ic... any swiftech retailers.. they are also very good.

[Jaite]

Would you prefer a swiftech over antarctica? Also, would tygon tubing go well with a swiftech?

[killzone]

yes i would preffer swiftec ofantartica thats just me also with the swiftech you wont have to remove the retension model just use the p4 style clips that come with the block, and tygon tubing will work just fine

[MaxxxRacer]

go with the swifty... tygon is great with everything.