predator500
02-15-2005, 09:58 PM
Ok here is the problem my mach 1 will run for like 10 mins. and get down to
-47 and this is with it running with out the computer on but then the temp starts to clamb to about -38 then the compressor shut down form over heating and it does this with the pc on or off so what i would like to know is if it may be the the compressor going bad or what it could be i think it might be the oil maybe braking down couse it would make since to me that with out oil it would overheat but im not for sure. This is my first phase change for pc as far as somthing like the mach. I know about phase change cause i am level 2 industrial ammonia operator but i also know that this is different so if you could help please help me i would love to get this thing running.
Here are my specs
P4 3.0e pressy
IC7 MAX-3
BFG 6800 GT
OCZ PC 4400
OCZ 520 Watt Powerstream
120 maxtor hard drive
-47 and this is with it running with out the computer on but then the temp starts to clamb to about -38 then the compressor shut down form over heating and it does this with the pc on or off so what i would like to know is if it may be the the compressor going bad or what it could be i think it might be the oil maybe braking down couse it would make since to me that with out oil it would overheat but im not for sure. This is my first phase change for pc as far as somthing like the mach. I know about phase change cause i am level 2 industrial ammonia operator but i also know that this is different so if you could help please help me i would love to get this thing running.
Here are my specs
P4 3.0e pressy
IC7 MAX-3
BFG 6800 GT
OCZ PC 4400
OCZ 520 Watt Powerstream
120 maxtor hard drive