i hitted a invisible wall

[Snowman89]

okey this it is, my sys wont be stable when ocing.
even at 211fsb i get errors in superpi dont know whats the problem is im running 3.1v thru memory 2-2-2-5 bh-5 and if i run them separatly i can achive 240fsb 2-2-2-5.
so what is the problem????
starting to get really despret right now.

my sys:
3200+ winchester
2x256mb bh-5
520w ocz powerstream
msi k8n neo2 platinium

[enzoR]

bad cpu controller? have you tried memtest?

[Feiticeira]

have u tried running less volts through them at 211 bus?

[Snowman89]

okey now im really pissed, i cant even get this :banana::banana::banana::banana: to be stable@stock!!!!
something is really wierd here!
enzor:memtest gives me 50 errors with 3passes, alla errors on test 5

[enzoR]

and if you have only 1 stick of mem its fine?

[Snowman89]

and if you have only 1 stick of mem its fine?
yeah, havent tested in memtest but others yes, you dont have msn or something like that?

[situman]

i heard BH-5 and MSI dont mix well together

[Snowman89]

i heard BH-5 and MSI dont mix well together
well if i ust run with 1stick in i can say it really works good because i can hit 260fsb 2-2-2-5 with 3.4v

[enzoR]

buy TCCD that works better as he said, BH doesnt play on MSI.

[Snowman89]

buy TCCD that works better as he said, BH doesnt play on MSI.
doesnt play?
dont understand, btw got to 280fsb 2-2-2-5 3.6v noot stable not stable for print :D will try with 2sticks again soon

[Michael]

He's saying that the MSI motherboard that you are using does not like your Winbond BH-5 chips. However, it performs very well with Samsung's TCCD chips.

There are some motherboards that prefer Micron G's over the TCCD's, etc.

edit: And have you tried loosening the timings?

[Snowman89]

He's saying that the MSI motherboard that you are using does not like your Winbond BH-5 chips. However, it performs very well with Samsung's TCCD chips.

There are some motherboards that prefer Micron G's over the TCCD's, etc.

edit: And have you tried loosening the timings?
yepp tryed 2.5-4-4-8 before at stock speed didnt work, dunno what i did now but it works at stock but not over that

[Snowman89]

is there something in the bios that needs to be disabled or enabled so it would oc good with dual?

[Snowman89]

yeeeyee!!!
220fsb stable!!
but over that is no go, tryed 3v up to 3,8v no good.
what can the problem be?
running the cpu on lower multi so it isnt holding me back

[Stealth5325]

BH-5 Works fine on this board, I'm currently looping Memtest5 as I type this at 3.45v. There's a HUGE thread about it in the AM section, check there.

[Snowman89]

BH-5 Works fine on this board, I'm currently looping Memtest5 as I type this at 3.45v. There's a HUGE thread about it in the AM section, check there.
what bios are you running?