Minnyboy
12-21-2004, 02:43 AM
I started a thread regarding freezing issues with my Vapo PE/3200+ Winnie/K8N Neo2 that was never resolved.
I thought it might have been the 90nm not standing the cold being the problem so i threw in my "spare" 3500+ NewCastle.
Turned my rig on & once the vapo hit -10c 9what i set it to start at), all I get is beeps.... WTF :confused: :confused:
Any ideas??
Took out the ddr booster, reset CMOS, took everything out but the CPU, RAM, Vapo, VC & still nothing but beeps...
Tried my KHX3200 instead of my XMS3500 & still nothing...
This mobo/cpu combo worked fine on air. It's only since I put it under the Vapo that these issues have started arising...
Is this the COLD BOOT ISSUE?? I thought it only affected Winnies & cold temps, not NewCastles...
Any ideas?? :mad: :mad:
Minh
I thought it might have been the 90nm not standing the cold being the problem so i threw in my "spare" 3500+ NewCastle.
Turned my rig on & once the vapo hit -10c 9what i set it to start at), all I get is beeps.... WTF :confused: :confused:
Any ideas??
Took out the ddr booster, reset CMOS, took everything out but the CPU, RAM, Vapo, VC & still nothing but beeps...
Tried my KHX3200 instead of my XMS3500 & still nothing...
This mobo/cpu combo worked fine on air. It's only since I put it under the Vapo that these issues have started arising...
Is this the COLD BOOT ISSUE?? I thought it only affected Winnies & cold temps, not NewCastles...
Any ideas?? :mad: :mad:
Minh