PDA

View Full Version : IN/OUT on evaps?

Shahid_2dk
12-10-2004, 05:50 AM
Hello fellows :D

I have been readomg trhough Lardarse's articles, and I have seen a few other evaporators

But I can only see where the capillary tube goes in, and not where the gas gets out from.
You get me?

I see where the gas gets in from, but where does it get out from ?

It is very easy to see it on watercooling heads, 2 pipes :D
f00t
12-10-2004, 06:24 AM
there are two ways to run the cap tube from the evap back to the drier. one is for it to go directly out of the evap and, in most cases, be wrapped along the suction line. the other method is to just run the cap tube through the iside of the suction hose, which provides slightly better cooling.
Shahid_2dk
12-10-2004, 12:03 PM
there are two ways to run the cap tube from the evap back to the drier. one is for it to go directly out of the evap and, in most cases, be wrapped along the suction line. the other method is to just run the cap tube through the iside of the suction hose, which provides slightly better cooling.



the second suggestion is almost like an ordinary water cooling head, right? :D
gclg2000
12-10-2004, 09:15 PM
there are two ways to run the cap tube from the evap back to the drier. one is for it to go directly out of the evap and, in most cases, be wrapped along the suction line. the other method is to just run the cap tube through the iside of the suction hose, which provides slightly better cooling.

Thats how imma do it
Shahid_2dk
12-11-2004, 02:13 AM
Hey people, can you show it to me on a picture?
PLZ :D
gclg2000
12-11-2004, 12:27 PM
search the boards, i'm sure someone has a pic of it
SlackeR
12-11-2004, 05:30 PM
Hej shahid :)
the thick tube you see is not the capillary - on most systems you can't see it because it is covered up. the thick hose is where the gas gets back to the compressor. That is the suction hose.
The capillary is the very thin copper pipe, and is normally run either inside or around the suction hose.
when the capillary is wrapped around suction it will normally enter next to the suction hose.
When run inside suction you wont be able to see it, most people will route the cap away inside the evap.
We can discuss it in danish if you want - PM me here, on Tweak.dk or on ocinfo.dk