PDA

View Full Version : need mod for Enermax EG465AX-VE (W) FCA

woutertal
10-21-2004, 07:01 AM
Hi all I have this PSU.. It's been behaving very well. However I need to raise the 12V rails a touch.. does anybody know of a mod?
Hell-Fire
10-21-2004, 07:39 AM
Post a pic of the ATX Connector please.
woutertal
10-26-2004, 05:01 AM
Sorry for answering so late, for some reason the forum mailer didn't let me know that there was an answer here.

On my ATX 20 pin connector there is only one sense wire, the 3.3V sense wire on pin 11.

I think that answer's yr question. The bats of my camara are low.. if you need a pic anyways please let me know.
Hell-Fire
10-26-2004, 03:57 PM
Be sure to check the middle of the ATX bundle as sometimes they hide the 5v sense wire in that 5v power wire that is in the middle of the connector.

Otherwise, time to open the supply up and take a look.
woutertal
10-28-2004, 02:39 AM
I'm positive there is no 5V sense wire. Some time ago I found this:

http://www.over-clock.com/ivb/index.php?showtopic=1494&hl=enermax

As you can see I tried to get some clues from thses guys.. even e-mailed them.. no joy. On the PCB in my PSU there is loads of glue.. I scraped most of it away to be able to get to the components underneath. I do not have resistor R82.

I do have the equipment and the skills to do a mod, or to measure around in the PSU. Look at post no 39 in the thread. It might be R73 ( I do have that one). If I measure voltages on it, what would I be looking for?