[HELP] Which one is the oil one???

[Malachia]

which tube i must cut to change the oil???

[hatemi]

You don't need to cut any tubes. Just turn the compressor so that the suctionline or the service port is at the lowest position of the compressor and drain the oil out of that. Try to shake it and make sure you get all the oil out and fill it with the same ammount of new oil:)

[Malachia]

guys i have tried :D

then i have two that inspires the gas and one that pull it out!!!

the exit is the vertical one....


EDIT no oil service port :stick:

[gkiing]

I've never seen a compressor with an oil service port, but I have seen one with oil coolers (which are mostly useless). You remove oil from the discharge tube (the smallest tube on the right of that pic) and add it through the suction line (the largest tube on the left, are there 2 pipes on the left or what?

[Malachia]

I've never seen a compressor with an oil service port, but I have seen one with oil coolers (which are mostly useless). You remove oil from the discharge tube (the smallest tube on the right of that pic) and add it through the suction line (the largest tube on the left, are there 2 pipes on the left or what?


no one is the electrical cable :D

ok then i will try to change oil!

then which tubes i must use?
the vertical and black one is the exit instead the other two are in...one is bigger than the other...