View Full Version : Mach II starts at once when it gets 230V
Kamerat
10-07-2004, 06:55 AM
I got a little problem with my Prometeia Mach II. Problem is that it starts at once when i plug in the power cable. The relay on the circut board isn't burned and it also reacts when i give the unit 230V. It doesn't boot if I disconnect the thermo sensor, so that seems to work just fine. Someone with any suggestion on what the problem may be?
first, check if you have a short on the molex connector :D
Wingz
10-07-2004, 08:06 AM
also try re-flashing the firmware using bootloader.
Kamerat
10-07-2004, 08:25 AM
Gonna try it out guys. :)
Someone who knows where the firmware can be downloaded?
Wingz
10-07-2004, 08:26 AM
Gonna try it out guys. :)
Someone who knows where the firmware can be downloaded?
http://nventiv.blue-nexus.com/
VoRtAn_MaDgE
10-08-2004, 11:18 AM
Same problem here...
Problem solved...
Uninstall all the stuff that u have installed concerning the mach2
Then download and install the Mach2 Control Center 1.23...
Install it...
Download the newest firmware...
Use the mach2 bootloader to flash it with the new firmware ...
DONE!
[]'s
Kamerat
10-09-2004, 04:58 AM
Thanks alot guys! A flash brought my Prommy back to his old self... :D
Running without any load:
http://home.no.net/comerade/-82c.png
:banana4: