PDA

View Full Version : 3.3V rail OVP, solution?

KODE
09-17-2004, 12:32 PM
Hi,

My TTGI 350SS is modded like the hell-fire's guide but OVP kicks in at 3.70V. I'm currently feeding mem with 3.5V and running the 3.3V rail @3.66 but I need at least a 0.2V margin between 3.3 rail and the Vdimm to avoid fluctuation on Vdimm.

Is there any way to overcome the OVP on this PSU?

Regards,

KODE.
jess1313
09-17-2004, 03:44 PM
Hi,

My TTGI 350SS is modded like the hell-fire's guide but OVP kicks in at 3.70V. I'm currently feeding mem with 3.5V and running the 3.3V rail @3.66 but I need at least a 0.2V margin between 3.3 rail and the Vdimm to avoid fluctuation on Vdimm.

Is there any way to overcome the OVP on this PSU?

Regards,

KODE.


yes i would like to know this as well, i have done a fair bit of searching to no avail. i have an Antec TC 550w. OVP/OCP(dont know which one) kicks about 3.8v. and some times kicks at 3.7-3.75 on cold boots, and i have to turn the 3.3v rail dont, to get the PSU to kick in...

and suggestions?
jess1313
09-23-2004, 05:37 PM
humm ill take that as a no :toast:
KODE
09-24-2004, 07:22 AM
No need to worry buddy... I did it!! 3.3@3.8V now. :toast: Will post some pics and what I did later.
jess1313
09-24-2004, 04:18 PM
No need to worry buddy... I did it!! 3.3@3.8V now. :toast: Will post some pics and what I did later.

really that would be nice, although you must remember i dont have the same PSU as you ;)

-Jess-
KODE
09-25-2004, 09:48 AM
really that would be nice, although you must remember i dont have the same PSU as you ;)

-Jess-

Yeah I know that, but in putting this into the worst scenary you would at least know what to track ;)