freecableguy
07-08-2004, 07:28 PM
I changed out a couple of pots on my PCP&C 510 so that I could increase the 3.3V and 12V lines. I took the 12V line to 12.80V (all as measured by a MM) and the 3.3V line, which was at 3.45V to 3.68V. Before the modification when I had my VDIMM set to 3.2V in the BIOS it would always undervolt to about 3.08V or less....after the increase I now get 3.18 to 3.20V...solid! The point of all of this: if you Abit Intel board is undervolting the memory, try just increasing the line voltages...see if that helps!
-kris
-kris