burn out my is7?

[bh2k]

I know this is better suited to intel, but I needed a fast answer

Well I booted it up with
3.0 Maylay
PC2700 256mb some old infineon mem
my radeon9800
3gb HD
thermaltake 360w psu

I did a vagp vtt and vdimm mod to the board although from the looks only the vdimm was right as in the bios the vdimm was ...3.15, all the others were normal. The board froze on me and now I can't get anything to come up on the screen. Tryed my radeon9800 and radeon 7000 and my 2.0ghz so the cpu and the video card aren't the problem...the psu works fine as well and the memory registers fine in another computer....did I somehow fry the board? I don't notice any burn marks or anything?

[Detract]

Not good my friend. Have you tried checking the traces on your board for unwanted solder? Might pay as well to recheck the VR's, iirc dont the vtt and vdimm have to be proportional or something to that effect.

[bh2k]

Well I guess the board is south...but the thing I don't get it all the fans turn on the power and and on LED light up and I can hear the harddrive start the boot...all the chips generate heat and all the ram and video card generate heat as well....I just don't get my I'm not getting any displayed tryed my KHX and a pci video card to no avail...Is there a way I can undo the VTT and VAGP mods? Oh and vtt should be half of vdimm, but that did nothing as well...

[boshi]

what's a maylay?

[sparkie34]

Its where his chip was made

[bh2k]

I can't spell, Malay, but you can stop trying to be cool now.