sk8v, what does those voltage sensors show?

[quinx]

I have an sk8v and in MBM I can make it show 3.3v, 5v, 12v and vcore(1.5v) but there are two sensors that show 2.93 and 4.08, what the hell are those? What does your sensors show?

2.93 can't be Vdimm because i have it set to 2.6v in bios(uses 1002.19).

Does the card even have an sensor for vdimm? I've tried several programs but i havent got anyone show Vdimm.

[xgman]

No vdim readout as far as I know. I measure mine on the board with a multimeter. I don't know what those other 2 are, if anything meaningfull. I have noticed a different vcore reading with every program I tried. No 2 the same. Bios, Asus Probe, MBM, Sandra, CPUZ etc. All different.

[quinx]

Yes, i have different Vcore as well in different programs, very odd. From 1.44-1.5.

I think I might know what these sensors do, i think it is -12v and -5v.

Where on the board do you messure your Vdimm?

I have really strange voltage readings, in bios they are something like 3.3=3.15 5=4.95 12=4.71-4.77 but if i messure with my multimeter i get (from molex and aux) 3.3=3.38 5=5.06 12=11.92. Its especially the 3.3 thats weird.

Are your voltage readings that odd to?

[xgman]

I have my rails dialed up high with a pcpc 510. As far as where to read the vdim, look down in this thread a few posts, but don't use the "turbo" mode in the bios, it overvolts/spikes the voltage no matter what you set it to.

http://www.xtremesystems.org/forums/showthread.php?s=&threadid=21972

[quinx]

Ok!

But how much is the difference in voltage readings from the bios vs multimeter, are they the same?

[xgman]

There is no vdim reading in bios and I haven't measured the vcore form the board.