PDA

View Full Version : Project IC7 finished!

Malves
03-04-2004, 02:26 PM
Bro, I wish I wouldn't have sold this baby. She's going to a new home tomorrow. :)

Too bad I don't have any 800FSB CPU to test it the way she should be tested.:(

vdimm
http://www.malvescorner.com/images/ic7vdimm.jpg

vtt
http://www.malvescorner.com/images/ic7vtt.jpg

vnorth
http://www.malvescorner.com/images/ic7vdd.jpg

vagp
http://www.malvescorner.com/images/ic7vagp.jpg

Special thanx goes to hipro5 for showing on how to do most of this stuff.
sandman
03-04-2004, 02:36 PM
that's nuts dude.

Nice job, what wire did you use?
Malves
03-04-2004, 02:42 PM
IDE cables.:D
Techmasta
03-04-2004, 05:54 PM
Is that liquid electrical tape around the pot's legs?
Malves
03-04-2004, 05:58 PM
Yes, it's. Can't go wrong with that stuff. After taking the shot of the vagp mod, I put some over the wires to avoid any accidents. ;)
lalPOOO
03-04-2004, 05:59 PM
Thats one sexy job! Nice work!
I have yet to do the Vnorth, VAGP and VTT on my board, but hopefully I'll get around to them when I have time to test. I also wanna try that cap beside the northbridge thing, but I can't find that kind of capacitor at all. I'll spent probably 3 hours checking sites online and I've got nutthun :(
Whoever gets that board is going to be a happy camper :D
Stang_Man
03-04-2004, 06:06 PM
very nice job malves! nice and clean :)
Malves
03-04-2004, 06:34 PM
Thanx a lot guys. I assure you I had lots of fun.:D
Gogeta
03-04-2004, 06:52 PM
All I can say is wow. You're mods look like they were done by Abit! lol

Awesome job Malves, keep up the good work :toast:
baker18
03-04-2004, 06:56 PM
Great mod. Looks very professional.

baker18
Confused_User
03-04-2004, 07:15 PM
I like how you use IDE cables for the wires. :D
Hell-Fire
03-04-2004, 08:45 PM
Supa sexy mods Malves.

Top rate job.
PytonOrm
03-05-2004, 01:50 AM
:D Great done.... well m8 what are you using for stuff to do this modd ??? 10k Ohm or what :) tell me
Malves
03-05-2004, 03:59 AM
Thanx everyone.:)

Pyton

Using 200 ohms for the vdimm/vtt/vagp and 50k for the vnorth. Here's the link (http://www.malvescorner.com/ic7.htm). :)
Hobocrow
03-05-2004, 06:09 AM
Great job! Excellent work ... very professional and inspiring! :toast:
Phyrox
03-05-2004, 01:48 PM
Very mod :) Very clean and professional.
[XC]thewildblue
03-05-2004, 01:57 PM
Nice job wish I could do that sort of thing.
hipro5
03-06-2004, 12:21 AM
VERY nice work Malves ......... :) :toast:
kommando
03-06-2004, 12:30 AM
Thats a very clean soldering job!!