-7 on mach1?

[Djake]

Hello.

Just installed my new Abit Ic7 max3, and the tempeture in bios is about -7 to -11.. The display on the mach1 are -36 to -40.. with my old mobo (asus p4c800) the asus probe was something like -20- 28

And btw my cpu is running default 3.2 right now.

Please help:confused:

[dpa]

asus shows to low temps.

[Djake]

yeah. but -7? that is high right? its a intel 3.2 800mhz fsb. 512kb

[Marci]

s'about right. Mobo sensors rarely show the correct temp. Go by stability and oc-ability. If it'll OC to the nuts and stay stable then it's fine. If it won't then your contact isn't good enough (basically).

[Tom Holck]

Agree with Marci,

Also try to bench Pifast og SuperPi, with the temp-program on.
You will be surprised, you'll se temp above zero...

The temp change you can use to messure the kontakt.

My results:
Standard Prommy March 1 at 1.76 volt was -11

On my IC7 the temp on March I modded R404a was -23 at 1.86 volt.

The Cascade was N/A (below -26) at 2.1 volt also at full bench, and bad kontakt:D

[thesaucier]

Im not sure but it seems the evap temps -36 to -40 are too cold and you may not have good contact with the cpu.

[Djake]

Thank you guys, that’s great. Ill try to check the contact today. With MBM it’s -17 idle and -14 running superpi. But still on default voltage.

I only got my Mach1 for something like a week, but I keep learning :)