Gforce 3 Vmodd?

[toolbox]

I've searched and found nothing so far.

Any linkage?

[Holst]

www.google.com

type "geforce3 voltage mod"

Lots of mods there, if you cant find one for your specific card we may be able to help you adapt one or work out something new.

[Lasac]

There is:

http://www.xbitlabs.com/articles/video/display/titanium-overclocking.html


On my old Ti200 i've used 1,2k pot for gpu and 2k for mems! ;)

[toolbox]

Thanks guys :)

[mattsmall]

http://www.xtremesystems.org/forums/showthread.php?threadid=27656

[toolbox]

The onyl thing that bothers me is I have a vanilla Gforce 3, all the modding I see is for TI200 and TI500...

[mattsmall]

Originally posted by toolbox
The onyl thing that bothers me is I have a vanilla Gforce 3, all the modding I see is for TI200 and TI500...

i did the mod on my vanilla Gforce 3 and i use a 1k vr resistor and set it at 800ohms. i wouldnt use anything bigger than a 800ohm

its the same mod but the core voltage stock is diff
geforce3 ti200 1.46
gforce3 1.53
gforce3ti500 1.53

[Anarki]

I am going to voltmod my Ti200 tomorrow, see if I can achieve 11k + 3d marks :D

I have read the guide and I have good soldering skills but my electronic skills are a little bit, flakey.

Would putting a 910Ohm resistor instead of a 1kOhm be Ok, same if I put a 1k2Ohm instead?

Also does it matter which way round the resistor is placed?

Final question could someone tell me where to use my multimeter to measure the Vmem/Vcore. A simple diagram would be great :)

I hate the fact that I cant get past 515 on the mem, I want at least 540 :D

Thanks, Anarki.

[X-Ecutioner]

the lower the resistance the higher the volts will be ...

get a variable resistor ...
set it to 1k?(or whatever) and if u want higher volts just decrease the resistance

dunno where to measure but u can calculate the volts just like they did ...

X

[mattsmall]

Originally posted by Anarki
Would putting a 910Ohm resistor instead of a 1kOhm be Ok,

Also does it matter which way round the resistor is placed?

I hate the fact that I cant get past 515 on the mem, I want at least 540 :D

Thanks, Anarki.


a 910ohm resistor would be fine for the core.

it dosnt matter which way the resistor is placed

you would see more 3dmark gains out of overclocking the core then the mem.

[Anarki]

Thanks for your help dude :thumbsup:

Arghhh I hate the UK, I cant find anywhere that sells 1kOhm or 910Ohm resistors, that are in stock, and to top that off my soldering iron still hasent shipped yet :cussing: