I sure do love my BH-5!!!

[Orian]

Had the chance to use stang_man's power supply with a modded 3.3v rail. (3.6v/5.1v/12.2v) on my droop/vdimm modded P4C.

3.4vdimm yielded these results...

http://www.7mpower.com/orian/computer/images/BH-5_265mhz.jpg

What is max vdimm I should run? I only stopped at 3.4vdimm for fear of frying the ram.

[afireinside]

I talked to Jason when I was thinking of getting an A64 rig and he said 3.6 would be ok fo benching. I'd feel safe shoving 3.7V at it for an hour of super pi ;)

Nice OC BTW :toast:

[Stang_Man]

we're scared to pump more than 3.4 vdimm through these sticks..

we didn't notice much of a difference between 3.3V and 3.4V though..

[Gef]

Are they stable at this speed and volt?

[Orian]

We didn't have enough time to test them for stability, but they did do 270mhz for a minute, then locked.

[Gef]

Originally posted by Orian
We didn't have enough time to test them for stability, but they did do 270mhz for a minute, then locked. With my XMS3200LL rev 1,1 i can boot up and do some tests with 260MHz 3,2v :D

[afireinside]

Common go for 3.6V :p:

[macci]

Nice going :D

BH5 is sooo NICE (http://www.akiba-pc.com/e107_images/articles/khx/p4c_khx_ddr550_cpuz.gif) ;)

[Garrett]

Please send me some Macci, my CH5 craps out on me and will NOT do 5-2-2-2 :( :D

[computerpro3]

How many volts did that take, macci? I think I may have a shot at getting there as I can do 265 2-2-2-5 @ 3.3v so if I shove 3.6 through these babies...

[TheWeaseL]

I'd put 4v down it for benching if I had the mod to do it...