View Full Version : Phase change project
NitroRat
12-12-2003, 06:40 PM
Well, getting ready to begin my new phase change system. My old case has been outgrown and a replacement was in order. Below is the old.
NitroRat
12-12-2003, 06:41 PM
the inside no room for phasechange
NitroRat
12-12-2003, 06:50 PM
I am currently running a 2500 barton at 2450 mhz with a 226 watt pelt being powered by a 25amp meanwell pwr supply with the cooling by a automotive heatercore by two 120's (55-60 cfm) sucking a one 120 (125 cfm) blowing. Motherboard monitor displays 2c at idle and 8c at load. I am still on the fence about going direct die or starting with a chiller, well anyway here is the new case I just picked up at Reboot computer near my house. Its not new but has more room and will need some mods to work.
NitroRat
12-12-2003, 06:52 PM
Had to remove the old dual pent 90mhz mb and others to make way.
NitroRat
12-12-2003, 06:53 PM
All the dead soldiers
NitroRat
12-12-2003, 06:55 PM
And my brand new TPE1390YXA Tecumseh compressor has a test fitting ...
NitroRat
12-12-2003, 06:57 PM
opps here you go.
NitroRat
12-12-2003, 06:58 PM
will have to trim the drive bays so it will fit closer to frt of case
Marci
12-13-2003, 06:17 AM
looks like the perfect case... keep us posted!
NaHeMiA
12-13-2003, 09:39 PM
wow looking good so far.
get a bakerblock :)
Pimpsho
12-13-2003, 09:44 PM
oooh! i cant wait to see this thing transform!!!:cool:
afireinside
12-13-2003, 09:45 PM
Originally posted by Pimpsho
oooh! i cant wait to see this thing transform!!!:cool: