How to run vapo without reset and powerswitch on mobo?

[Jvlk]

Well i hot wired a psu...and when i turn it on compressor gets on for a second or 2 and than shuts down again.
I have a classic vapo model and i want to run it without any wires on mobo.
Because i use the vapo for cooling my vga and i use a prommie machII for cpu.

Anyone have a idea how to get it to run with out reset and power switch on mobo?

thx

[Tedinde]

Just jump the ATX connector, green to black. Works on mine,

[Marci]

If that's what you're doing but it still stalls then the PSU you are using is too weak fer the job...

[Jvlk]

But it works when i boot it up when wires are attached to mobo...with the same psu:confused:

[Marci]

The PSU may need load on the 5v rail as well as the 12v rail to balance it out. Grab a 120mm fan and run it off the 5v rail at same time as the Vapo.

[Jvlk]

Already tried it (cd-rom):rolleyes: ....checked psu when vapo is running (just with mobo attached) and i get a reading of 11.98v. :confused:

I think it needs the reset plug in mobo...for chill-control..but how can i let the vapo think he's attached to a mobo.:confused:

[Marci]

Definitely doesn't fella. Spent the past few weekends running a vapo PE just by shorting ATX Connector, with nuthin at all plugged to mobo.... unless things are different with the older chill-controls.

Is the PSU kicking out enough ampage (ignore voltage.... ours fires up happily with 10.5v)

[Jvlk]

I already have it running....i tried other cd-rom and it just booted up now:confused:
But what the hell...everythings fine now.

Thx for all the help:rolleyes: