CPU TEMP with MACH 1

[Jojo1971]

at idle my CPU temp is -19C , then at full load with prime95 it goes up to -10C to -3C...is that too high for an unmodded mach1?

what temp would i be getting if i will have this prommy modded to R507? will the mod shorten my prommy's life? forgive me for asking such questions coz im really new to phase-change..i'd just like to solicit some ideas before getting this prommy modded...

[Marci]

that's fine. Flip thru the forum for info on the 507 mod, all your questions have already been asked and answered in other threads....

[NaHeMiA]

With R507 you will be getting about -49 on the evap for load. Your idle temp wont be displayed because it will be too cold.

However the evap temp is notyour cpu temp. Just find out the difference between your evap temps and cpu temp and subtract that from -50 and that will be your load temp

talk top fugger if you want a r507 mod done. it will be cheaper then r404a

and btw those cpu temps were fine

back when i had my 3.0c @ 4ghz w/ vapope unmodded my evap temp at idle would be -20c and copu temp would be 3~7c

[ThommY]

Im sorry to bring this old thread up again, but i just put my first steps in phase changing and got my mach I installed on my xp1800+. Its running @ 1.8vcore and 2425mhz like it was in my h2o setup. I'm getting idle temps from -10 to -3, depending on my room temp. Is this normal? Or is my cpu contact bad? I checked before and the thermal past gave me a nice print on the evap so i gues those temps are normal?

[ThommY]

Thx MickeyMouse! That's all i needed:D