PDA

View Full Version : GA-EP45-UD3P and ICH


mrbudgie
10-20-2009, 06:47 AM
Lo All

Wasnt sure if this could go in the other GA-EP45-UD3P as it looked like an overclocking only thread.

right then you GA-EP45-UD3P experts need some advice please.

I have the GA-EP45-UD3P MB and OCZ 1150mhz Flex RAM. when sticks work and load fine on own but more than 2 sticks in and it goes into reboot loop.
asked OCZ and they said to put MCH and ICH to 1.34. I have put MCH to 1.34 but not the ICH wanted to check first that the ICH would be safe volt and temp wise at 1.34.

my case is a stacker and MY Q9550 is water cooled by a custom loop with 2 x 240 rads outside case so I aint got a much air flow as an aircooled processor so temps on them bits that OCZ said to VOLT up does worry me.

thanks ian
truehighroller
10-20-2009, 07:08 AM
Lo All

Wasnt sure if this could go in the other GA-EP45-UD3P as it looked like an overclocking only thread.

right then you GA-EP45-UD3P experts need some advice please.

I have the GA-EP45-UD3P MB and OCZ 1150mhz Flex RAM. when sticks work and load fine on own but more than 2 sticks in and it goes into reboot loop.
asked OCZ and they said to put MCH and ICH to 1.34. I have put MCH to 1.34 but not the ICH wanted to check first that the ICH would be safe volt and temp wise at 1.34.

my case is a stacker and MY Q9550 is water cooled by a custom loop with 2 x 240 rads outside case so I aint got a much air flow as an aircooled processor so temps on them bits that OCZ said to VOLT up does worry me.

thanks ian


Set your voltage for the Memory to 2.1 and you reference for the Memory to .80 and leave the two channel references at auto and see if that resolves the issue as I have those memory sticks in mine and they work fine.
mrbudgie
10-20-2009, 07:24 AM
meant to add mine is rev1.1 and bios f6 i think

i'll give it a try the reference bit i take it is with the DDR voltages
truehighroller
10-20-2009, 07:41 AM
meant to add mine is rev1.1 and bios f6 i think

i'll give it a try the reference bit i take it is with the DDR voltages


That might be your issue. I have rev 1.6.
aslanwas
10-20-2009, 09:23 AM
I think thats not a problem of your mobo ?!?!?!?!

I got yesterday my 4*1GB OCZ Flex 1150 with Micron D9 and they didn't work @ quad channel, first when i put 2 sticks off, the system began to work again, and they went up to 1400 5-5-5-15 2,8V :D :up::up::up:

MoBo: P35-DS4

Maybe take the latest bios, but i don't think that this problem will be solved by updating the bios
mrbudgie
10-20-2009, 01:53 PM
tried all the settings and the ones from OCZ but no luck.

any one else got any ideas before i try just bite the bullet and buy some gkill or patriot or someting more compatible with this board