View Full Version : Please Help, Not A Newbie
:confused: Hi all,
my rig, just changed a Cpu ( for a up grade ) done it many many time.
My rig now starts then stops, starts, stops & would do it not stop !!
Took every other component out tested, all ok.
Put the old Cpu in does the same, starts, stops.
Its like when a cpu over heats then shuts down, you check the paste and so on :shrug::shrug:
Please Help.
64dragon
10-17-2009, 05:36 PM
have you tried clearing CMOS?
lutjens
10-17-2009, 09:13 PM
Is the fan connected to the CPU fan header or a different fan header on the board? In the past, some boards would turn of if they weren't getting a signal from the CPU fan header on the board. Unsure if this practice has continued to the present, but worth checking. Also, check all power wiring in the case (4 pin connectors primarily) for a case short that may be tripping your power supply.
My $0.02...
Leeghoofd
10-18-2009, 12:39 AM
any bend pins in the socket ? removed the battery ? get the mobo out of the case and try again
Sam_oslo
10-18-2009, 01:01 AM
Rolling reboots could indicate a shortcut too. Maybe you got an extra bolt under your MB?
Is the fan connected to the CPU fan header or a different fan header on the board? In the past, some boards would turn of if they weren't getting a signal from the CPU fan header on the board. Unsure if this practice has continued to the present, but worth checking. Also, check all power wiring in the case (4 pin connectors primarily) for a case short that may be tripping your power supply.
My $0.02...
Morning, no full water cooling, going to check all things out now :rolleyes::rolleyes: will get back to you all.
Thanks :)
any bend pins in the socket ? removed the battery ? get the mobo out of the case and try again
Done battery, will get mobo out start again.
Easybeat
10-18-2009, 05:13 AM
Have you checked the memory voltage? mine defaults to 1.8v when I reset CMOS but it requires 2.1v to operate.
Caused me 2 hours of heartache one day that did.
Have you checked the memory voltage? mine defaults to 1.8v when I reset CMOS but it requires 2.1v to operate.
Caused me 2 hours of heartache one day that did.
No, but I cant do anything just starts, stops, so frustrating if only I could get to bios ????????????.
Just so stuck, my last atempt is to buy a new mobo, if I new this I would have bought the lastest stuff