Classified model numbers? Revision?

[Schlotkins]

I'm looking to buy a classified to upgrade from my Asus P6T Deluxe V1. I see most vendors have:

141-BL-E760-A1

but microcenter has:

141-BL-E761-A1

What's the difference between the two? I'm assuming it's probably the same hardware since there's not E761 BIOS updates on EVGA's website.

Also, there seems to be some rumors of a new revision of the board. Any info on that?

Thanks,
Chris

[wondergod]

761 has the ECP control panel addition. However the motherboard is the exact same.

[Schlotkins]

Thanks for the info... now I just have to figure out if I can get this Extended ATX board in my non-Extended ATX case. :)

[wondergod]

what case? i'm search if you do a google search on your case+mobo you could probably find something or someone who has the combo or tried it.

[zanzabar]

its not a full eatx board its just a little wider than normal ATX it should fit almost all cases

[Schlotkins]

Well, I'm going to have to think now... it's an older Antec mid-tower. Perhaps a SLK3700AMB? I googled it but nothing. I was thinking about getting an Antec Solo case but I couldn't find anything definite about that case either.

I think, based off my measurements, it will fit as long as the holes are in the same spots.

Thanks
Chris

[zanzabar]

the classified is 12x10.38 instead of 12x9.6 so just measure it

[LiberalElephant]

The holes are in the same spots. It's less than an inch wider than standard ATX so MOST cases are good.

[indiecom]

Both of are the same...But 761 with ecp..