DavidNJ
12-20-2008, 11:36 PM
DFI LP UT P45-T2R...but the important info is Q6600 B3. Memory is Corsair `1066 Dominator, but only at 900 now. Expect to move the CPU to my 780i and move a Q6700 to the DFI next week.
Actually lost some time because a stick was going bad. After it failed and replaced I became stable very quickly. With a .7 ratio and 1.2 or 1.3v VTT, 1.5v CPU VID, holding 360x9 for 9+ hours on Prime 95. However, 370MHz. causes crashes and freezes.
Since the memory is 1066 running at 900 (4:5 multiplier) I don't think that is the problem; however, I am open to any suggestions.
3.24Ghz probably isn't terrible for B3. I think close to 390x9 may be possible; I was running without freezing at those at one point a year ago, but then on air couldn't handle the heat. Now it is on water and polished.
Any advice is welcome.
Actually lost some time because a stick was going bad. After it failed and replaced I became stable very quickly. With a .7 ratio and 1.2 or 1.3v VTT, 1.5v CPU VID, holding 360x9 for 9+ hours on Prime 95. However, 370MHz. causes crashes and freezes.
Since the memory is 1066 running at 900 (4:5 multiplier) I don't think that is the problem; however, I am open to any suggestions.
3.24Ghz probably isn't terrible for B3. I think close to 390x9 may be possible; I was running without freezing at those at one point a year ago, but then on air couldn't handle the heat. Now it is on water and polished.
Any advice is welcome.