PDA

View Full Version : vappo or prommy on A64 what temps in bios?

Stinger
10-18-2003, 03:48 AM
My r404 mach 1 prommy shows -43 full load on lcd and -15 -17 in bios at 1.9v 2400mhz what temp are you getting?
Pedro Rocha
10-18-2003, 06:33 PM
Does the A64 motherboards (KT800 and NF3) hold the reset correctl with the Prometeia 1???
DoGMaN
10-18-2003, 07:13 PM
Originally posted by Pedro Rocha
Does the A64 motherboards (KT800 and NF3) hold the reset correctl with the Prometeia 1???

The ASUS K8V does.
LardArse
10-19-2003, 12:58 AM
Originally posted by MickeyMouse
at 1.9v at only 2400mhz I would take it all apart and get a new chip, lol.. I did 2480mhz today on reg water cooling 12c cool water wiht a swiftech "GPU" block at 1.7v

Jason, 2.5 Ghz with just 30C water 2.04v here ;) I find voltages seem to help a bit more than cooling.
saaya
10-19-2003, 01:15 AM
the architecture of the a64 isnt that diferent from the xps, they added and doubled a lot of stuff, but the main axhitecture is exactly the same. so i think a64s can take a lot of voltage, just like the xps. 2.2 with nice cooling should be fine and will probably not fry the chip or let it die from electromigration. and since its on soi it might be able to take even higher voltages than xps... but who has the cooling to run them higher than 2.3v anyways? :D
Major
10-19-2003, 01:58 AM
Right now at idle I'm getting -20 according to mbm, and lcd on vapo shows -43 standard Mach 1 with mb horizontal. That at 2.4ghz and 1.68v according to mbm
Major
10-19-2003, 02:11 AM
And after 10 or 12 minutes of prime95 I'm at -8 according to mbm, and promie shows -33, this is with the IHS still on the cpu.