View Full Version : Mach2 weird problem
Boogotop
10-11-2003, 04:25 PM
ok...on the lcd that say* NO MAINS* and a temps like 30celcius and the led say error 6...and the compressor doesn't start at all...and on nventiv site that says:
*LED Error 6
Question: What does this error mean ?
LEDS: Error Code 6
LCD shows: NO SHUT DOWN
Answer: The PC has not been shut down (dead lock). The compressor continues to cool.
Solution: Turn off the PC manually and verify that the yellow wire from the cooling unit is connected properly to the motherboard. If problem persists: Contact support@nventiv.com*
what guys do you think...broken prommy???
Marci
10-11-2003, 04:28 PM
Make sure the molex connector from prommi to pc is connected, and that the ATX PSU of the PC is plugged in and switched on. If the prommi doesn't detect 12v on the yellow / black molex relay wire then it shuts down assuming PC has failed.
Boogotop
10-11-2003, 04:35 PM
....i've made all of that today....damn...that piss me off!!!
Boogotop
10-11-2003, 09:06 PM
anyone....opinion???
Marci
10-12-2003, 11:29 AM
Run is thru exactly how you have it hooked up etc and we might be able to help more... we can't see it from here... pix would help.
We need to know exactly how you've wired it up, what hardware (mobo etc) you're using it, what wattage PSU etc etc. Details m'boy... details!
Boogotop
10-12-2003, 05:44 PM
ok...i've tried first with my ASUS K8V....nothing except...*RESTARD DELAY 120sec....and after 20sec that write*NO MAINS and evap temperature*...after i've tried with my old NF7 rev 2.0 and Barton 2500+....same thing...and last....same thing with my ABIT IC7 and 2.8C
the compressor just never start.... :(
JCviggen
10-13-2003, 12:27 AM
At the risk of sounding incredibly stupid here, you DO have the power cable plugged into the back of the cooling unit right...? Because it sounds like it doesnt get any power somehow
Marci
10-13-2003, 04:17 AM
I was trying to avoid asking that question as my tact and subtlety gland was a bit poorly last night!
Boogotop
10-13-2003, 07:25 AM
Originally posted by JCviggen
At the risk of sounding incredibly stupid here, you DO have the power cable plugged into the back of the cooling unit right...? Because it sounds like it doesnt get any power somehow
lol...yeah dude of course....that look like a electric problem....damn...the unit just never started....i hope kit-tronics will exchange it now...i don't want to be without prommy for 3 month
NyCUndaGrounD
10-13-2003, 07:34 AM
I Can't emphasize how important it is to make the right connections. Try removing the yellow wire from prommy and try to power up the board with a screwdriver. Also make sure that none of the pins are loose at the back of the control board. Hope u wont have to return it.
Boogotop
10-13-2003, 07:56 AM
ah dude....i've passed around 16 hours on trying to make it run...nothing...i think kit-tronics will exchange it direct....the unit just never started and i live at 35miles of our local