PDA

View Full Version : Water cooling Mem OCZ Flex XLC



ntvh
06-20-2008, 03:25 AM
Hi All,

Is there anyway I can change the liquid connector from 1/4 to 1/2 for OCZ Flex XLC PC2 9200? Thanks

Thankful for all advice and suggestion.:up:

ntvh
06-20-2008, 08:53 AM
any body Please

Do you need more info?:confused:

Asgard_thor
06-20-2008, 10:55 AM
I think there are things, that convert them, but I don't think you can swap them

ntvh
06-20-2008, 11:08 AM
Ahhhhh.. please help.

philbrown23
06-20-2008, 02:36 PM
they make reducers from 1/4 to 1/2 inch but it would be more of a hassle than anything.

ntvh
06-20-2008, 02:53 PM
with 1/4 hose and 1/2 hose ....the cooling of the Ram will be effect it or it is the same?? Thanks

Serra
06-21-2008, 05:19 AM
You can just buy a reducer. Even if you found a way to change out the barbs on the actual RAM it wouldn't make a difference to the flow itself, the channels in the RAM aren't terribly large.


with 1/4 hose and 1/2 hose ....the cooling of the Ram will be effect it or it is the same?? Thanks

Yeah, you'll equally add lots of nearly pointless restriction to your loop either way.

Vinas
06-21-2008, 05:53 AM
You can just buy a reducer. Even if you found a way to change out the barbs on the actual RAM it wouldn't make a difference to the flow itself, the channels in the RAM aren't terribly large.
Yeah, you'll equally add lots of nearly pointless restriction to your loop either way.
+1 ... terribly small if anything

ntvh
06-23-2008, 11:43 PM
For now, I'm going to stay with this. Thank you for all of your help
http://www.ocztechnology.com/products/memory/ocz_ddr2_pc2_9200_flex_ii_4gb_series:clap::clap:

Hidetaka
06-24-2008, 01:04 PM
Wouldn't using manifolds make sence here? It would do less damage to flow if you split the tubing and connect it after water's gone through RAM WBs, and memory won't need much cooling anyways.

ntvh
06-24-2008, 01:17 PM
Yes that is the way I will do for loop. I'm going to use the splitter one will go in to CPU then go out to the water dispenser, and the other one will go to NB,SB, Mosfet and RAm then will go to water dispenser with Cold control to 5 Degree C, My water pump with be submerg. I don't want go to sub 0 to much to take care of.:D:up:
http://www.alibaba.com/product-free/10177338/Hot_Cold_Water_Dispenser.html?pn=4&pt=4&total=4&cids=200016338,200016791,50002664,200000869,501446 60,50036249,50135552,50029822,50035543,200000233,5 0002181,50019391,50081268,50039687,200039002,50141 897,200019171,200017408,200015303,200015997,501382 43,50146055,50038049,50030857,50073708,200000030,&tracelog=detailtop12907&newId=10177327#page960