PDA

View Full Version : It's normal?

User111
05-12-2008, 11:10 PM
Yesterday I do a small test with my cpu
http://img211.imageshack.us/img211/9034/34001xz8.jpg
http://img362.imageshack.us/img362/6928/3400kl6.jpg

this temps are too high? (my e4400 cooled with noctua nh-u12f [infact because of the temp are too high, imho, I rotate my cooler from

http://img368.imageshack.us/img368/9196/pict0124uu4.th.jpg (http://img368.imageshack.us/my.php?image=pict0124uu4.jpg)
to

http://img528.imageshack.us/img528/1042/pict0197yo2.th.jpg (http://img528.imageshack.us/my.php?image=pict0197yo2.jpg)
and the vcore is 1,488)
It's normal?
zanzabar
05-12-2008, 11:16 PM
it looks a little hot what tim did u use and do u have good contact
Serpentarius
05-12-2008, 11:48 PM
i recall the guide to o/c involves "not to have ur temp breach the 70 deg celcius limit"
that'll might burn ur processor ... be very careful .......
Xel'Naga
05-13-2008, 12:16 AM
The temps are high due to the following reasons:
1.The 4xxx series are pretty s**ty compared to the 6xxx series, with higher average leakage current so they will heat more at the same speed&vcore
2. The way you had it first, the HSF was taking hot air from the graphics card which increased the temperature by about 5 degrees Celsius(from my experience)
3. Someone correct me if I am wrong but I believe that the 4xxx are not soldered so the die has very poor contact to the IHS, resulting in bad temps even with a good cooler
Retro
05-13-2008, 04:13 PM
What he said ^
Also, perhaps consider getting an E8400 for better performance at lower temps.:cool:
adamsleath
05-13-2008, 04:14 PM
too hot; if it melts get a penryn:hehe: have you got a tight enuf mount with the heatsink?
my tuniq dont get that hot even with 1.5+V e4300...

but these things have a tjunction of 85C dont they?
:shrug: 1.4V loaded i get up to 68C with TAT
User111
05-13-2008, 11:56 PM
too hot; if it melts get a penryn:hehe: have you got a tight enuf mount with the heatsink?
my tuniq dont get that hot even with 1.5+V e4300...

but these things have a tjunction of 85C dont they?
:shrug: 1.4V loaded i get up to 68C with TAT

the screws are hold, in excess I damage the cpu. No? The thermal paste cover uniformally the cpu...:shrug:

my tjunction is, with Coretemp 0.96, 100°C