Flip_Lx
03-31-2008, 12:02 PM
Well i've got this case incoming and plan to do some minor mods to it.
First does anyone know what size LED it uses in the front of the case? are the 5mm or 3mm?
Second what is the best way to cut the top of the case? I want to add a recessed handle to the center but so far only have access to a dremel. Will that be enough or is there something else i can use that will be a lot easier to work with?
Third, has anyone used a bulgin resistant switch on this case? Would the 22mm fit where the normal power button is or would i have to file/enlarge that hole a bit more? From what i've seen on my friends case its about the same size but i can't be sure.
Any help on these would be appreciated
First does anyone know what size LED it uses in the front of the case? are the 5mm or 3mm?
Second what is the best way to cut the top of the case? I want to add a recessed handle to the center but so far only have access to a dremel. Will that be enough or is there something else i can use that will be a lot easier to work with?
Third, has anyone used a bulgin resistant switch on this case? Would the 22mm fit where the normal power button is or would i have to file/enlarge that hole a bit more? From what i've seen on my friends case its about the same size but i can't be sure.
Any help on these would be appreciated