Mach2 heater connection

[Tingle]

Hi,

Just in the process of setting up my mach2 system, taking ages to clean out my old watewr system, cut up pipes for video card and put it all together!

I have hit a problem when i came to put connect the heater

Basically, the 2 fittings do not and will not go together.

I am using the right plug! The one coming from my motherboard has 2 connections, each with 6 sides, however, the one from the prommi unit has 2 connections, on that will fit but one of them is square

Is this just me or what?

What should i do now? Just go and shave a bit of plastic off?

Thanks

[Marci]

Firce em fella... make sure the clip part lines up and you'll notice one of the pegs is slightly square when it really shouldn't be. Either force em together like I did, or shave the corners off the one that's wrong...

[Tingle]

Ok thanks for the quick reply

PS, the email i just sent you was on the same topic marci - ignore plz

tingle