Prometeia mach II Newbie

[newkid]

Hi i well be getting a prometeia mach II soon and i new to the whole vapor cooling thing. Anyway i just got the bottom unit and i want to use it with my c3 clear case. So i wanted find out is anything else than cutting a hole for the thermal bus that i whould need to do. Also any other info/tips whould greatly be appreciated

Thanks
John :banana: :toast:

[Scott]

Id guess you'd need to drill the holes for the Fixing Bolts, so when you move it the to pand bottom move together :)

When i drilled mine (Mach 1 mind) it was just a standard 6mm hole, wouldnt have thought they'd have changed size for the Mach 2.

[Scott]

Oops, forgot as well.

Depening on your Motherboard and Tray, you may need to cut a hole for the backing plate to sit it, if you dont you will end up bending you mobo, which i found out is a costly mistake.

What Mobo you be using with it?

[newkid]

Thanks scott for info.:D

Iam most likey going to use my dfi lan party board.

John :banana:

[Scott]

Depending on the Size of the Risers on your mobo tray, you may need to cut the hole in the try.

before you stick the Backing plate to the mobo, just rest it on the try, place the mobo on it, where it needs to be. Then screw a few in, see if it bends the mobo.

If it does, get your dremel out :)

[newkid]

Thanks Scott for the info

I have been reading stuff on prometeia and i have heard some problems with condensation. Should i do something extra to help provent it? :smileysex

Thanks
John

[Scott]

If its all installed correctly, you shouldnt have a problem.

bowman is the man for that sorta stuff, hopefully he'll see this thread and offer some advice for you :)

[eagle101]

wrap that rubber string real good on the front and back of board
2 or 3 times i did and zero problems no leaks....perfect
youll be ok pal dont worrie like they all say do it right the 1st time
later......