View Full Version : Replacement for selastring?
KingInge2000
08-17-2003, 10:54 AM
Are there any non Chip-con Products which can be used instead of sealstring?
Thaddy
08-17-2003, 10:56 AM
I think auto shops use the exact same seal string, and they'll sell it to you for a lot less.
If you've just run out of seal string, though, collect your current/old one into a ball and start rolling it. Believe it or not, you end up with perfectly fine seal string. ;):toast:
TheDude
08-17-2003, 12:37 PM
I used to use something very similar to seal metal roofing sheets against water leaks. There are probably lots of subsitutes if you look around. :D
bowman1964
08-17-2003, 04:01 PM
ok this is what chip-con uses.
bowman1964
08-17-2003, 04:02 PM
and product info
Originally posted by bowman1964
and product info
I'll have to check around for that. The 1/4" would be nicer than the 3/8" I got at Schuck's Auto Parts. If someone is happy with 3/8" then Schuck is a good source in the US. It was $12 for 15' IIRC.
KingInge2000
08-17-2003, 11:59 PM
Originally posted by bowman1964
and product info
THX. Thats what i needed. But its hard to find the german edition.