PDA

View Full Version : Is Vapochill LS getting better or is it just fluke? :)



jinu117
11-09-2007, 09:47 PM
I will have to find out from owner of this unit but for first time in my dozen of vapochill mod, I found a unit that can hold 200w!!!! Albeit not that great of temp but still, the fact it held 200w confirms me that there are some units that are doing well some quad. Some things unusual about units on this one were heavy whistling noise from suction line, and bit lower idle temp than typical one's I've seen and compressor not approaching 85c! (it reached close to 80c though).
I don't think I will have enough time to disect it's cap tubing, etc but this sure is interesting.

Oh, of course, it failed beyond that... but still, interesting for me indeed.

n00b 0f l337
11-09-2007, 09:49 PM
Yep seen that before. One out of six or so. I think they might be older Rev's? Whistling I didnt have though...

Pete
11-10-2007, 05:10 AM
Jin, where you measuring T1 and T2 temps?

Moc
11-10-2007, 05:20 AM
T1= Loadtester
T2= Evap

jinu117
11-10-2007, 06:04 AM
Correct. Evap close to the original probe location. Just to see if they cleaned up the mass yet... NOPE... it reads okay till about -25c and than differential gets larger and larger...

tim-
11-10-2007, 09:40 AM
you should be happy, I tried to run the EU version it with 230w, it was reaching +10 then I didn't have the balls to see how much more it holds without mod.

regards
Tim