Maximus Formula SE Vdroop

[-=j0nnyr0773n=-]

I have the Maximus Formula SE and it is drooping about .1v under load. I mean I set it to 1.55 bios and cpuz shows 1.45 while Priming. I know there is a pencil mod and am planning on doing it, but wasn't the 0505 bios supposed to fix this? I updated to that bios before doing anything to that board and I still have pretty large droop (in my opinion). Also, I have seen that other boards have a bios setting to try and stop the vdroop, I don't see one for the Maximus though, am just overlooking it?

[sofarfrome]

check this (http://www.xtremesystems.org/forums/showpost.php?p=2465806&postcount=1) post...voltage damper is there, just need to enable it.

[CERO]

I have the Maximus Formula SE and it is drooping about .1v under load. I mean I set it to 1.55 bios and cpuz shows 1.45 while Priming. I know there is a pencil mod and am planning on doing it, but wasn't the 0505 bios supposed to fix this? I updated to that bios before doing anything to that board and I still have pretty large droop (in my opinion). Also, I have seen that other boards have a bios setting to try and stop the vdroop, I don't see one for the Maximus though, am just overlooking it?


Loadline calibration @ enabled? Because thats like the voltage Damper on the P5K deluxe.

[-=j0nnyr0773n=-]

Enabled Loadline Calibration and it is solid. Thank you very much

[CERO]

Enabled Loadline Calibration and it is solid. Thank you very much

cheers :up: