XPC SD37P2V2 Mods??

[Riska]

Hi i am looking for some mods for the shuttle SD37P2V2.
First i want to have more juice for the chipset and second i want to have more juice for the ram 2.1v isent quite innof.
There is a Shutle SD39P2 and it is 99.99% the same as the SD37P2V2 only thing different is that there is only one pci-e port and one pci port where the SD37P2V2 have 2 pci-e ports in the SD39P2 bios u can set the vmem to 2.4v and u can adjust the chipset volt i have looked at the bios for the SD37P2V2 but there issent any thin hidden in it like more voltage and i have tryed to flash the SD39P2 bios over to the SD37P2V2 whit no luck it can start but it vil not turn on the Gfx card..
Can someone help me whit some mods i have some pics but they arent any good because my digicam issent wery good.

[Riska]

http://img.techpowerup.org/070420/SD37p2723.jpg
Here is a pic of the mobo i hole

[Riska]

No one how can help me?

[Riska]

Bummer

[Riska]

It is kinda dead in here..

[Nosfer@tu]

Persivore migth be able to help you m8.

And why not just hard mod the stuff?

[Riska]

That is also what i am looking for

[Riska]

Come on guys isint there someone ho can look it over and help me?

[Riska]

Ok 82 people have looked at this post but no one can help

[Riska]

Is there some one ho can point out where i might look for the chip for the vmemmod and the chipsetmod look at the pic above

[Riska]

Nasty dead in here!!!

[Riska]

Come on no one ho will try there powers on this board?

[Riska]

Still noone??

[Timbosan]

Posting that many times isn't necessary. Not many people can look at a picture and design a mod without any other information. Making mods from a photo that is too large, and unclear (not high res) is next to impossible. It would really help if you provide close up high res photos of the voltage controllers on the mobo. We can look for IC's that may be responsible for voltage supply to various components.
I have circled 3 areas in green - take close up photos of these areas and post em. Provide the codes from the top of the multi-leg chips in the centres of the places ive circled. Theres 2 of the chips in one area provide codes for both.

[Riska]

I will take a look

[Riska]

Here are some pics

[Riska]

More pics

[Riska]

Final pics i cant take any better pics because my digicam is awfull

[Riska]

Sorry for the bad pics but my digicam is no god.
Is the pisc god enouhg for helping to find the mods?

[Timbosan]

Its quite difficult without a multimeter. With that you could probe pins to find voltages etc. I found the datasheets for 1 or 2 of those chips, but the one that looked most promising (NCP 5220) seems to be different to any datasheets i saw for it. It appears to control Ram voltage (vDDQ) and memory controller voltage (vMCH). Without a DMM to probe around with its not looking promising. I would not hold high hopes of that board being modable - you'd be better off getting a more mainstream overclocking board and going from there. The ADP chip probably controls vcore & modulates vdroop. I cant upload the ADP data sheet its too big. This is the only 5220 datasheet i could find, but the IC looks different to the ones used on your board.

[Riska]

Ok thanks
I will try to get some readings out of it some day