DFI SLI-DR,Corsair 3500LL and 4000+ KAB1E

[BadNizze]

Hello!
Today I got my refurbished SLI-DR! I need it to push my 4000+ to it´s limit. And I´m wondring about drivestreghts, whitch level are you guys using? I´m at Auto for now...System is in sign. Also are there any other settings I should know of before I start the serious clocking. My last board was an Amd\Ati Rd580 board so it was totaly diffrent. BTW The DFi board has great voltage stabillty for cpu but undervolts like crazy...1,475 in bios gives 1,424 @ Cpu-z, any thougts? \\Hope my spelling is ok...

[BadNizze]

Basic results...And pic ;)
My Cpu Kab1e 0626 FPMW, Same Cpu old mobo
http://i30.photobucket.com/albums/c338/Swe_Eric/P2040037.jpg
Prime...
http://i30.photobucket.com/albums/c338/Swe_Eric/Sp2004-2.gif

[NightCrawler™]

I must be an idiot or something but that pic shows an Asus A8N-SLI mobo and not a DFI SLI-DR...

[Kasparz]

Basic results...And pic ;)
My Cpu Kab1e 0626 FPMW, Same Cpu old mobo
...

[BadNizze]

Mobo in pic is Asus A8R32-Mvp :fact: I dont know if i could trust samartguardian but my PWMIC temp is 60C during prime and Chipset is 50C is this ok, or should I consider better cooling? Cpu cooling is TT BIG and I´m using a Antec P180 with three Nexus fans, Top fan is pushing air into the case and rear fan is pulling air out o case. Best regards BadNizze

[Lastviking]

Mobo in pic is Asus A8R32-Mvp :fact: I dont know if i could trust samartguardian but my PWMIC temp is 60C during prime and Chipset is 50C is this ok, or should I consider better cooling? Cpu cooling is TT BIG and I´m using a Antec P180 with three Nexus fans, Top fan is pushing air into the case and rear fan is pulling air out o case. Best regards BadNizze


Get a fan over the pwmic stuff(you see the heatsinks)

[BadNizze]

Get a fan over the pwmic stuff(you see the heatsinks) I´ll try that

Just know I moved my computer down into the basement to do som cold air runs with my cpu...Whent into bios and seclected the 150 divider and know she whont boot,I tryd clering cmos and it boots...at stock settings but as soon as I go inte to bios and start changing stuff it will not boot....:mad: I´m being a real pain in the but here but try to beare with me....Again sorry for bad spelling....

[Viss]

What bios are you using? Try multi 11 with divider 150 to see if that works. On me 146 opteron 150 divider didnt work with multi 10. Put a fan over the 3 heatsinks right from socket, lower pwmic does help stability.

[BadNizze]

shipping bios -> realy old. It wont post so I can´t enter bios :mad: Tryd only one stick of my Corasir 3500LL in the top orage slot but no go. The leds on my Corsair is acting strage aswell...During startup only every other led working... Rest of system is in sign