View Full Version : Mach 2GT problems!
FrozenShinobi
10-02-2006, 05:00 PM
My fuse blew out on my mach 2 and I took it out and it appears to be a 6.3A ceramic 5x20mm fuse. The only fuses I could find were the exact same ones but not ceramic, should I try the ones I have to see if they work? Can I damage anything if they end up not working right?
EDIT: Fuse fixed, new problem in post below.
trance565
10-02-2006, 05:42 PM
why did you start another thread? why not just post in the one you already had? and dont worry about what material they are made of, so long as they are rated for the same amps thats all that matters if they both fit.
Nagaru
10-02-2006, 05:55 PM
why did you start another thread? why not just post in the one you already had? and dont worry about what material they are made of, so long as they are rated for the same amps thats all that matters if they both fit.
The fuses also need to match in there "speed" or how long it takes to blow, because compressors pull a huge amount of current on start up they often use slow blow fuses.
sdumper
10-02-2006, 06:05 PM
Frozen did you PM Waxy like i suggested? I had good reasons...
FrozenShinobi
10-02-2006, 06:25 PM
Yeah I sent Wax a tell... I think I got the fuse figured out now. Thanks everyone.
FrozenShinobi
10-02-2006, 07:14 PM
Well I think the fuse works now, but I have bigger problems. When I plug in the mach the green light blinks. I push the power button a bunch of times but it does not react, then after a while of being on it appears to start and reset a bunch of times, while the red light blinks, and one yellow light blinks, one yellow light stays lit, and green light still blinks. What is causing this error?
FrozenShinobi
10-02-2006, 08:23 PM
The green light blinks, the second light (yellow) blinks, the third light (yellow) stays lit without blinking, and the fourth light (red) blinks. I think this is either binary code 3 or 7 which means either HOT STOP or COOLING FAULT error?