turok_t
08-29-2006, 04:53 PM
Hey guys,
I have 2 x Hyundai L90D+ and 2 x eVGA 7900GT CO SC (580/1580) and im using Forceware 91.36. When im on my desktop, im using Horizontal Span between my 2 LCD. When I try to right click on either of my screen, my screen on the right would usually go black for a few seconds and then return to normal. When I go the display properties in the “Settings” tab under “Advance” my right screen also gives me a quick blank. When I click on the “7900GT” tab in the NVIDA panel, I also see the blank screen on my right LCD. Its driving me crazy and I remembered that before I format, it was never like this. Here are some of the things I have tried but still failed to fix the problem:
1)Format my entire computer
2)Install older and newer forceware drivers
3)Installed monitor drivers
4)Used the “Auto adjust” function on my monitors
5)Changed the VGA cable for my right monitor
6)Since I have 2 monitors plugged into my video card, I tried to swap them around.
7)Change the refresh rate
8)Auto detected each monitor again
So I tried all those things listed and nothing seemed to work. As well, within the NVIDIA panel, under “nView Display Settings, it shows which monitors you have. The funny thing is that the primary display shows L90D+D-SUB which is correct by my secondary display shows Analog Display which is wrong. Before I formatted, both monitors were shown as L90D+D-SUB. I attached a pic at the bottom for u guys to see. Im not sure how to fix this and I think it is related to the blank screen problem above. I tried to switch between digital and analog output on my monitor itself, but it failed to work. Any help would be appreciated. Thanks guys
I have 2 x Hyundai L90D+ and 2 x eVGA 7900GT CO SC (580/1580) and im using Forceware 91.36. When im on my desktop, im using Horizontal Span between my 2 LCD. When I try to right click on either of my screen, my screen on the right would usually go black for a few seconds and then return to normal. When I go the display properties in the “Settings” tab under “Advance” my right screen also gives me a quick blank. When I click on the “7900GT” tab in the NVIDA panel, I also see the blank screen on my right LCD. Its driving me crazy and I remembered that before I format, it was never like this. Here are some of the things I have tried but still failed to fix the problem:
1)Format my entire computer
2)Install older and newer forceware drivers
3)Installed monitor drivers
4)Used the “Auto adjust” function on my monitors
5)Changed the VGA cable for my right monitor
6)Since I have 2 monitors plugged into my video card, I tried to swap them around.
7)Change the refresh rate
8)Auto detected each monitor again
So I tried all those things listed and nothing seemed to work. As well, within the NVIDIA panel, under “nView Display Settings, it shows which monitors you have. The funny thing is that the primary display shows L90D+D-SUB which is correct by my secondary display shows Analog Display which is wrong. Before I formatted, both monitors were shown as L90D+D-SUB. I attached a pic at the bottom for u guys to see. Im not sure how to fix this and I think it is related to the blank screen problem above. I tried to switch between digital and analog output on my monitor itself, but it failed to work. Any help would be appreciated. Thanks guys