P5W DH raid0 set up

[panda_boy]

right i need to know if im doing the right thing. I wanted a raid0 set up so i removed one of the blue jumpers so it would work in raid0 and connected the oranger s-ata cables to EZ-RAID1 and EZ-RAID2 and then hooked them up to my two Hitachi Deskstar T7K250 250GB. Will that work fine ? i just did wot the manual said but it didnt specifie wot s-ata cable to use do i use the red or orange. Plus i have an DVD writer that uses S-ata so i connected that to the red master Sata-1 connecter on my mobo will this be alright. any help would be great guys.

[One_Hertz]

right i need to know if im doing the right thing. I wanted a raid0 set up so i removed one of the blue jumpers so it would work in raid0 and connected the oranger s-ata cables to EZ-RAID1 and EZ-RAID2 and then hooked them up to my two Hitachi Deskstar T7K250 250GB. Will that work fine ? i just did wot the manual said but it didnt specifie wot s-ata cable to use do i use the red or orange. Plus i have an DVD writer that uses S-ata so i connected that to the red master Sata-1 connecter on my mobo will this be alright. any help would be great guys.

cable colors dont matter at all. You should be fine.

[XenatR]

what is raid? (seriously)

[Weedsqueezer]

Redundant Array of Inexpensive Disks. RAID 0 is aka a stripe, it sends half the data stream to each disk simultanously for amazing read/write speeds...back On Topic. the setup all sounds fine, make sure you have the optical drive's jumper set to CSL or cable select. then all should work